Power Supply Inspection; Registration Check - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V

9.2.4 Power Supply Inspection

1. Disconnect the 3A fuse and check
its condition.
NOTE: The 3A fuse is installed on the
engine starter wire harness and located
at the right side of the fuse box.
Is the fuse in good condition?
YES – Go to step 2
NO – Replace fuse and
recheck.
2. Disconnect the connector from the control unit
3. Check for continuity between No.14 (black) and body ground.
Is there continuity?
YES—Go to Step 5
NO – Repair the open circuit
4. Measure the voltage between No. 9
(Red/White:+) and No. 14 (Black:-)
terminals.
Is the voltage over 9.0V
YES -- Go to step 5
NO – Repair the open circuit in the
lead
5. Reconnect the connector, and go to Registration Check. Section 9.2.5

9.2.5 Registration Check

1. Connect the tablet tester to the under dash
data link connector.
2. Push the command/lock buttons on the
transmitter to start the vehicle.
3. Insert the key, turn on the ignition switch
and connect to the vehicle using the HDS
tester.
4. Under "R/C Engine Starter", "System
Check" follow the instruction on the screen
and ensure the system is normal.
Is the system normal?
YES -- Continue to check transmitter.
NO – Register the control unit or transmitter as required and recheck.
24
Table of Contents
R/C Engine Starter
System Check
System is/is not normal