Engine Starter Registration; Transmitter Registration - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V

22.0 Engine Starter Registration

Note: The following procedure will guide you through the registration of the remote control engine
starter. These instructions are also provided on the R/C engine starter installation instructions
and the HDS screens when performing the registration.
A Pocket Tester can be used for registration but due to limited screen space will not provide
proper instruction. In step 9 the Pocket Tester does not instruct the installer to push the command
and unlock buttons that are necessary to complete the registration. As such, it is recommended
that you use the HDS NOT the Pocket tester to ensure a proper registration.
1. Acquire the PCM Code from E-BIZ.
2. Connect the tablet tester to the under dash data link connector, and turn the ignition switch
on.
3. Start the Honda Diagnostic System, and click the car icon
4. Input the VIN and odometer information then click the check button.
5. Select the "Honda System", and click the check buttons.
6. Select the "R/C Engine Starter" and click the check button.
7. Select the "REGISTER REMOTE CONTROL ENGINE STARTER UNT" and click the check
button.
8. Check that "Register Remote Control Engine Starter Unit" is shown and click the check
button.
9. Check that "The immobilizer of the vehicle is normal." Is shown, push the command followed
by the Unlock/Stop buttons on the transmitter, then click the check button.
10. Input the PCM code, then click the check button.
NOTE: To ensure the security, the PCM code (password) is changed everyday, so it is
impossible to register the remote controlled engine starter if the date you received the PCM
code is different then the date you are registering the control unit. The tablet date also needs
to be correct for the PCM code to function properly
11. Check that "The registration of the Remote Control Engine Starter Unit has been completed"
is shown, then click the check button.
12. Ensure that "Check that the engine can be started by the transmitter." is shown, then click the
check button.
13. Turn the ignition switch off, and pull out the key from the ignition switch.
14. Close all windows and doors and ensure the tailgate and hood are closed.
15. Make sure that the engine starter operates properly.

22.1 Transmitter Registration

1. Connect the tablet tester to the under dash data link connector and turn the ignition switch
on.
2. Start the Honda Diagnostic System, and click the car icon
3. Input the VIN and odometer information and click the check button.
4. Select the "Honda System", and click the check buttons.
5. Select the "R/C Engine Starter" and click the check button.
6. Prepare the new transmitter to register.
7. Select the "REGISTER TRANSMITTER", and click the check button.
8. Within 7 seconds, press the Command button followed by the unlock/stop buttons until the
buzzer in the transmitter sounds.
9. Check that "Registration of transmitter has been completed" is shown
10. Turn the ignition switch off, and pull out the key from the ignition switch.
11. Make sure that the engine starter operates properly.
60
Table of Contents