Reset Control Unit; Ignition Line Inspection - Honda 2007 CR-V Service Manual

Honda Remote Control Starter System Service Manual: 2007 CR-V
vehicle switch/wiring problem if necessary.

9.2.9 Reset Control Unit

1. Remove and reinsert the 3A fuse.
2. Close all doors, lock the car and start the car
with the remote.
Does the engine run?
YES – Normal Condition. R/C starter will only allow
3 restarts without a 20 minute waiting period. See
section 5.3
NO – Go to Ignition line inspection

9.2.10 Ignition Line Inspection

1. At the control unit connector, check
for continuity between no 16 (Blue)
and No. 14 (Black) terminals.
Is there continuity?
YES – Go to Step 2
NO – Repair the open circuit in the
lead or replace the control unit.
2. Connect the + probe of the
voltmeter to the No. 5 terminal
(orange) and the – probe to the No.
14 (Black) terminal.
3. Push the Command and Lock/Start buttons on
the transmitter and check that the voltmeter
shows battery voltage momentarily.
Does the voltmeter show battery voltage?
YES – Go to step 4
NO – Replace the control unit.
4. Disconnect the 40A fuse between the white and
the light green leads
5. Check the fuse condition
Is it normal?
YES – Go to step 6
NO – Replace and Recheck.
26
Table of Contents
Vehicle fuse box
14 (BLACK): GROUND
3A fuse
5 (ORANGE): IG1 RELAY CONTROL
(As viewed from wire side)