Table of Contents
Advertisement
Connecting Digital VANGARD Mail Ports to the i-Series
Connecting Digital VANGARD Mail Por ts
Availability:
Voice Mail
Ports
1 & 2
COM
1
CONSOLE / COM2
(reserved for HOSTKEY use)
625 Modular Jack
Figure 20: Connecting Digital Voice Mail Ports to an I-Series Phone System
Chapter 2: Installing the Voice Mail
Connecting the Voice Mail to a Phone System
Connecting Digital VANGARD Mail Ports
Digital VANGARD Mail with version 10.06 or higher.
To connect digital Voice Mail ports to the an i-series phone system:
Make sure you do not accidently plug the line cords for the phone
system into COM1 or COM2 on the Voice Mail. This connection may
permanently damage the COM port.
1.
Refer to the illustration below:
Plug the short end of the line cord (where the ferrite bead is connected) is connected Ports 1/
2 connector on the back of the Voice Mail. Plug the other end of the cord into a Voice Mail
Interface Unit. Be sure you have installed the ferrite bead on this line cord.If you haven't, see
"Installing a Ferrite Bead on Each Line Cord" on page 22.
Voice Mail
Voice Mail
Ports
Voice Mail
3 & 4
Ports
5 & 6
Reset
Ferrite Bead
BLK
YEL
2.
Plug the other end into a 625 modular jack assembly.
Connect one-pair 24 AWG station cable to an odd-numbered station port in the i-Series
3.
telephone system.When you program the phone system for Voice Mail, use this odd-num-
bered port and the next even port. (See the installation manual for the phone system for com-
plete instructions on connecting an i-Series phone system.)
WARNING
Status
Ports
LEDS
7 & 8
AC Power
Connector
AC Power Cord
GRN
RED
VANGARD Mail/i-Series Quick Setup Guide
Ground
Stud
VAN-C8
AC
Adapter
To Odd-Numbered
Digital Extension
Circuit
25
Advertisement
Table of Contents
