Table of Contents
Advertisement
Placing the Voice Mail in the Proper Location
Placing th e Voice Mail in the Proper Lo cation
Wall-Mounting the Voice Mail
Chapter 2: Installing the Voice Mail
Placing the Voice Mail in the Proper Location
Place the Voice Mail cabinet on a sturdy flat surface, or mount it on a wall. During placement, be
sure to observe all requirements listed in the Site Requirements.
Before you can mount the cabinet on the wall, you will need the following tools and materials:
Phillips-head screwdriver
dry-wall screws
center-hole punch, nail, or other pointed tool
tape
hammer
paper wall-mounting template from the VANGARD Mail shipping box
To mount the VANGARD Mail on the wall:
1.
Tape the paper template at the desired location on the wall.
Note: The area for mounting should be spacious and free of obstructions to allow airflow around the
cabinet.
2.
Using a center-hole punch (or another pointed tool) and a hammer, strike 2 holes through the
paper template at the locations shown.
3.
Remove the paper template from the wall.
4.
Screw the 2 screws into the holes you punched, until the heads of both screws are about 1/8"
from the wall surface.
5.
Hold the Voice Mail cabinet, so that the bottom of the cabinet is facing the wall and the Port
Connectors are facing the floor.
6.
Using the two keyhole-shaped slots on the bottom of the cabinet, place the cabinet over the
screws until it touches the wall.
7.
Carefully lower the cabinet into place.
Promote adequate airflow around the unit by making sure that the fan vent slots and
ventilation holes on each side of the cabinet are clear of obstructions.
Installing the Voice Mail Hardware
CAUTION
VANGARD Mail/i-Series Quick Setup Guide
17
Advertisement
Table of Contents
