Table of Contents
Advertisement
Figure 11: Inserting the RJ Connectors into Ports 5/6 and Ports 7/8
Chapter 2: Installing the Voice Mail
Increasing the Number of Voice Mail Ports
Follow these steps exactly as stated. Failure to do so may result in damage to J7 on the
motherboard.
5.
With the card held at an angle as shown in Figure 11, make sure that the RJ connectors are
inserted in the openings marked for Ports on the cabinet. Figure 11 shows installing a card
into slot 2 so the RJ connectors should be inserted in the openings marked Ports 5/6 and Ports
7/8.
6.
Lower the card into position, making sure that the hole in the in the card lines up with the hole
in the standoff as shown in the illustration on the next page.
If the hole does not line up, repeat step 5, making sure that the RJ connectors are inserted
properly through the openings.
It is very important to insert the card so that the holes line up properly. Failure to do so
may permanently damage the card by flexing it when you apply pressure to the top of
the card.
Installing the Voice Mail Hardware
WARNING
WARNING
VANGARD Mail/i-Series Quick Setup Guide
15
Advertisement
Table of Contents
