Table of Contents
Advertisement
Front panel components
Connectors
NMI switch
8
Table 2: FortiGate-5001C LEDs (Continued)
LED
State
Blue
Flashing
IPM
Blue
Off
Table 3: FortiGate-5001C connectors
Connector
Type
CONSOLE
RJ-45
9600 bps
8/N/1
SFP+
10-gigabit/auto
1 and 2
SFP
1-gigabit/auto
1 and 2
RJ-45
10/100/1000
MGMT 1
Base-T
and
MGMT 2
USB
USB
When working with Fortinet Support to troubleshoot problems with FortiGate-5001C
boards with part number P10633-01 and up you can use the front panel non-maskable
interrupt (NMI) switch to assist with troubleshooting. Pressing this switch causes the
software to dump registers/backtraces to the console. After the data is dumped the
board reboots. While the board is rebooting, traffic is temporarily blocked. The board
should restart normally and traffic can resume once its up and running.
Description
The FortiGate-5001C board is ready to be hot-swapped
(removed from the chassis). If the IPM light is blue and
no other LEDs are lit the FortiGate-5001C board has lost
power
The FortiGate-5001C board is changing from hot swap
to running mode or from running mode to hot swap. This
happens when the FortiGate-5001C board is starting up
or shutting down.
Normal operation. The FortiGate-5001C board is in
contact with the chassis backplane.
Speed
Protocol
RS-232
serial
Ethernet
Ethernet
Ethernet
FortiGate-5001C security system
Description
Serial connection to the command
line interface.
10-Gigabit SPF+ connection to
10-Gigabit networks (port1 and
port2). Small form-factor pluggable
transceiver.
1-Gigabit SPF+ connection to
1-Gigabit networks (port1 and
port2). Small form-factor pluggable
transceiver.
Copper 1-gigabit connection to
10/100/1000Base-T copper
networks for management or
system administration.
USB key for firmware updates and
configuration backup.
FortiGate-5001C Security System Guide
01-400-181221-20121130
http://docs.fortinet.com/
Advertisement
Table of Contents
