Connectors - Fortinet FortiGate-5001B Manual

Front panel components

Connectors

8
Table 3: FortiGate-5001B LEDs (Continued)
LED State
Link/Act Solid
(Left Green
LED)
Blinking
MGMT 1
Green
and
Off
MGMT 2
Speed Green
(Right
Amber
LED)
Off
Blue
Flashing
IPM
Blue
Off
Table 4: FortiGate-5001B connectors
Connector Type
CONSOLE
RJ-45 9600 bps
8/N/1
SFP+ 10-gigabit/auto
1 to 8
SFP 1-gigabit/auto
1 to 8
RJ-45 10/100/1000
MGMT 1
Base-T
and MGMT
2
USB
USB
Description
Indicates the management interface (mgmt1 or mgmt2)
is connected with the correct cable and the attached
network device has power.
Indicates network traffic on this interface.
No Link
Connection at 1 Gbps.
Connection at 100 Mbps.
Connection at 10 Mbps.
The FortiGate-5001B board is ready to be hot-swapped
(removed from the chassis). If the IPM light is blue and
no other LEDs are lit the FortiGate-5001B board has lost
power
The FortiGate-5001B board is changing from hot swap
to running mode or from running mode to hot swap. This
happens when the FortiGate-5001B board is starting up
or shutting down.
Normal operation. The FortiGate-5001B board is in
contact with the chassis backplane.
Speed Protocol
RS-232
serial
Ethernet
Ethernet
Ethernet
FortiGate-5001B security system
Description
Serial connection to the command
line interface.
10-Gigabit SFP+ connection to
10-Gigabit networks (port1 to
port8). Small form-factor pluggable
transceiver.
1-Gigabit SFP+ connection to
1-Gigabit networks (port1 to
port8). Small form-factor pluggable
transceiver.
Copper 1-gigabit connection to
10/100/1000Base-T copper
networks for management or
system administration.
USB key for firmware updates and
configuration backup.
FortiGate-5001B Security System Guide
01-400-134818-20120216
http://docs.fortinet.com/