Figure 1-7. 2U library rack anchors and mounting brackets
6. Install the library mounting brackets ( 1 ) as shown on the 2U library on each side of the library using
the screw that was removed from your library and an additional short, counter-sunk screw included in
the rack kit. (The 4U rack anchors and mounting brackets are similar.)
7. With library rack anchors and mounting brackets installed, slide the library onto the rails (as shown in
Figure 1-8 and Figure 1-9 on page 1-8). When the library stops, gently push the library to lock the
anchors installed on each side of the library to the rails and until the mounting brackets are flush with
the vertical rack rails.
Figure 1-8. Sliding the 2U library into the rack
1
2
1-7
Installation