1.15 Side Covers R and L
(1) Lift up the front of the side cover R and take it out.
(2) Disconnect the main-sensor harness from the main PCB, and then lift up the front of the
side cover L and take it out together with the main-sensor harness.
Platen frame
Side
cover L
Tab
Reassembling Notes
•
Before putting back the side cover L, route the main-sensor harness as illustrated above.
•
When setting the side covers, put each rear edge under the tab and fit each hole over the
boss provided on the main cover.
•
After installation, check the routing of the main-sensor harness, referring to Section 1.29.
Routing of the main-
sensor harness
Hole
IV – 27
Side
cover R
Hole