Color - Brother FAX1170 Service Manual

(6) Remove the paper-edge sensor actuator by pulling the support "x" outwards.
(7) Remove the paper ejection sensor actuator by pushing the hook "y" from the rear of the
paper feed chute.
Latch
Latch
Paper ejection sensor
actuator
Paper feed
chute
Paper ejection sensor (PH1)
Paper-edge sensor (PH2)
(8) Pull up the separator pad while squeezing it to the right or left. The spring also comes
off.
Reassembling Notes
• Make sure that the paper ejection sensor actuator is set on the sensor PCB.
• As illustrated on the previous page, route the main-sensor harness through the cutout of
the platen frame. When routing it through the clamp of the paper feed chute, first put the
lead wires only into the clamp and then pull up the vinyl sheath.
Paper ejection sensor actuator
Sensor
PCB
Hook "y"
(Rear)
Sensor PCB
(Rear)
IV – 16
Paper ejection sensor (PH1)
Paper-edge sensor (PH2)
Paper-edge sensor
actuator
Support "x"
Separator pad
Spring
Main-sensor harness connector