Panasonic WJ-GXD400 Setup Instructions page 52

Problem
Refresh of live images is
unstable.
The web browser is discon-
nected.
Network performance is
poor.
The password is forgotten.
The audio output is not pro-
vided.
The resolution and transmis-
sion interval are not the
same as the specified val-
ues.
The clock of the camera is
not displayed.
52
Check item/Remedy
• The configured settings for transmission rate/record-
ing rate may be beyond the maximum network perfor-
mance.
Lower the value/rate of the settings relating to the net-
work such as the transmission rate from cameras.
• The line speed settings may be not the same between
the unit and the hub, for example, 100M BASE-TX
Full for the unit and 100M BASE-TX half, etc.
Some hubs change the line speed automatically
depending on the network traffic and it may cause
configuration errors.
Check the line speed settings of both the unit and the
hub, and configure the line speed setting of both to
conform them.
• Set the mode switch No. 1 on the front panel to ON,
and perform initialization by restarting this unit with
the reset switch (All the setting data is initialized at
that time). After initialization, set the mode switch No.
1 back to OFF.
• The audio output is not provided during the sequence
display (tour sequence/group sequence).
The audio output is not provided when the compres-
sion method is set to JPEG.
• The audio output is provided only at the default
screen.
• The audio output is not provided when the schedule is
displayed.
• The settings are recorder-dependent when images
are downloaded via the recorder, which disables the
settings of this unit. Check the settings of the recorder
and camera.
• If the date and time information is not provided with
images from the camera, even selecting other than
"Off" for [OSD] – [Time & date] does not display date
and time.
Reference
page
34
–
Page 12
of the
Installation
Guide
–
27
20