Panasonic WJ-GXD400 Setup Instructions page 21

I Display mode
Select either the "Full screen" or "Trimmed screen".
When the display mode is toggled, restart this unit.
If edges of an image are chipped in the full screen,
change the mode to the trimmed screen.
Default: Full screen
Important:
• If the border is always displayed, the screen is sus-
ceptible to burn-in. Therefore, setting the border to
Off is recommended.
[Screen ID]
A screen ID can be assigned to each split screen and
displayed.
1
Click the [Display] button on the setup menu.
2
Click the [OSD] tab in the setup menu.
The "OSD" window will be displayed.
3
Click the [Setup >>] tab in "Screen ID >>".
Refer to the following for further information about
the settings for each item.
Setup items
I 6-screen
Select an information position to be displayed on the
screen.
I 3-screen(primary screen on the left)
Select an information position to be displayed on the
screen.
Notes:
• Displayed characters may be overlapped depending
on the displayed position settings. If characters are
overlapped, the pop-up window is displayed.
• Check whether full resolution is available with the
connected monitor.
4
Click the [Set] button in "Screen ID setup".
I 3-screen(primary screen on the right)
Select an information position to be displayed on the
screen.
I 1-screen
Select an information position to be displayed on the
screen.
Up to 4 alphanumeric characters can be entered.
21