Beep Definitions; Scan Mode - Newland NLS-HR32 Series User Manual

【0006010】
【Enter Setup】

Beep Definitions

Beep Sequence
4 ascending beeps
1 beep
2 beeps
3 short low beeps and 2 high beeps
1 long low beep

Scan Mode


Manual Mode: A trigger pull activates a decode session. The decode session continues until the barcode is decoded
or you release the trigger.

Auto Mode: The scanner activates a decode session every time when it detects a change in ambient illumination.
The decode session continues until the barcode is decoded or the Decode Session Timeout occurs. Pressing the
trigger can also activate a decode session.

Continuous Mode: Pressing the trigger activates a decode session. The decode process continues until the
barcode is decoded. After finishing a decode session, the scanner automatically starts a new session until you press
the trigger a second time.
【Manual Mode】
**【Auto Mode】
21
Power up.
A non-programming barcode was decoded (if the Decode Beep is enabled).
A programming barcode was decoded (if the Decode Beep is enabled).
The scanner failed to decode a barcode (if the Decode Beep is enabled).
The scanner detected an unknown character when using USB HID-KBW (if
the Beep on Unknow Character is enabled).
【0302000】
【0302010】
Indication
【0302020】
【Continuous Mode】
【0006000】
**【Exit Setup】