Usb Holder, Usb-H/Usb Circuit Board, Rear Cover, Evf Unit, And Hand Strap - Hitachi DZ-MV580EAU Service Manual

Disassembly and Reassembly > Disassembly

(11) USB Holder, USB-H/USB Circuit Board, Rear Cover, EVF Unit, and Hand Strap

Note:
Before replacing the EVF unit, always perform "(1) BL DET Check" in "6-4-11 EVF".
USB Holder (a) and USB-H/USB Circuit Board (b)
1) Remove one screw [F].
2) Disconnect the USB-H/USB circuit board from MAN-H/MAN circuit board (h).
3) Remove the USB-H/USB circuit board from USB holder in the direction of the arrow.
Rear Cover (c) and EVF Unit (d)
4) Remove the hand strap from side case-R (g).
5) Remove one screw [F] and one screw [A].
6) Disconnect the three flat cables, and then remove the rear cover along with the EVF unit.
7) Remove one screw [A], and then remove the EVF unit.
Hand Strap (e)
8) Remove screw [A], screw [D] and screw [M], and then remove the hand strap.
(e)
4)
(a) USB holder
(b) USB-H/USB Circuit Board
(c) Rear cover
(d) EVF unit
(f) Hand strap plate
(g) Side case-R
(h) MAN-H/MAN circuit board
(d)
(f)
6)
8) [D]
8) [A]
(g)
(h)
Fig. 5-3-13
5 - 10
5) [F]
(c)
5) [A]
1) [F]
(a)
3)
2) (b)
7) [A]
8) [M]
6)
[A] M1.7x4 (Black)
[D] M1.7x4 (Black)
[F] M1.6x2.5 (Black)
[M] M1.7x3 (Black)