Table of Contents
Advertisement
Disassembly and Reassembly > Disassembly
(9) USB Circuit Board, Rear Cover, and Hand Strap (Fig. 5-3-11)
USB Circuit Board (a)
1) Remove screw [D].
2) Disconnect the flat cable from MAN circuit board (d), and then remove the USB circuit board
assembled with USB holder (e) from the R block.
3) Remove the USB circuit board from USB holder in the direction of the arrow.
Rear Cover (b) and Hand Strap (c)
4) Remove the hand strap from R block (f).
5) Remove screw [D] from the right of rear cover and screw [A] from the bottom of rear cover.
6) Remove screw [A].
7) Disconnect the two flat cables from MAN circuit board, and then remove the rear cover in the
direction of the arrow.
8) Remove screw [D], screw [P] and screw [E], and then remove the hand strap and hand strap
plate (g) from rear case.
(a) USB Circuit Board
(b) Rear Cover
(c) Hand Strap
(d) MAN Circuit Board
(e) USB Holder
(f) R Block
(g) Hand Strap Plate
[A] M1.7×4 (Black)
4
[D] M1.6×2.5 (Black)
[E] M1.7×4 (Black)
[P] M1.6×3 (Silver)
Fig. 5-3-11 USB Circuit Board, Rear Cover, and Hand Strap
A
(c)
(f)
4
5 [D]
(g)
A
8 [E]
8 [P]
B
B
7
(d)
3
2
(a)
(e)
5 - 9
6 [A]
8 [D]
(b)
7
5 [A]
1 [D]
Advertisement
Table of Contents
