Hitachi DZ-MV580EAU Service Manual page 43

Troubleshooting > Messages and Troubleshooting
Message
Scenes over limit.
Cannot move scenes.
Stop processing.
There was no scene which
can be deleted.
This card cannot be used.
Please replace card.
This disc cannot be used.
Please replace disc.
This disc is recorded by the
NTSC system.
Please replace disc.
Top scenes cannot be
divided.
UNFORMAT DISC
Use AC adapter/charger.
Cause/condition for
message to appear
Appears if an attempt is made to move a
scene at the upper limit of 999 scenes
registered, or the number of scenes will
exceed 999 by moving a scene. [Refer to
*1 page 4-9]
This message appears during operation
process. It will appear when user
interrupted any process by pressing the
stop/cancel button when processing
multiple scenes, etc.
Appears when only multiple locked
scenes were selected using the Disc
Navigation function, and deleting them
was attempted.
Appears when a card other than SD
memory card or MultiMediaCard was
loaded.
Appears when a type of disc that cannot
be used on the DVD video camera/
recorder was loaded.
Appears when a disc recorded in the
NTSC system was loaded: This DVD
video camera/recorder is exclusively for
the PAL system and does not comply
with the NTSC system.
Appears when the first image of scene
was selected to divide the scene: The
specifications state that dividing a scene
at its top is not possible.
Appears when an unformatted or
logically damaged disc was loaded.
Also appears when a dirty disc was
loaded.
If the message appears when a normal,
formatted disc has been loaded,
condensation might have occurred on the
lens or drive of the DVD video camera/
recorder. Condensation will occur when
the DVD video camera/recorder is moved
from a cold place to a warm place.
Appears if a battery is used when
finalizing a DVD-R disc. The
specifications state that DVD-R disc can
be finalized only when the AC adapter/
charger powers the DVD video camera/
recorder.
4 - 17
Troubleshooting
Delete unnecessary scenes before
moving scenes.
Operate the DVD video camera/
recorder after the message
disappears.
Use the Disc Navigation function to
unlock the scenes, and then restart
operation.
Insert an SD memory card or
MultiMediaCard.
Check the type of disc and insert a
disc usable on the DVD video camera/
recorder.
Use a disc recorded in the PAL
system.
Stop trying to divide a scene.
Format the disc (deleting all recorded
data), or replace the disc.
Clean the disc, or replace it.
[Refer to page 4-11]
Set the power switch to "POWER
OFF" with the disc loaded, and then
leave the DVD video camera/recorder
in a dry place until condensation
disappears (usually 1-2 hours).
Terminate the Disc Navigation
function, set the power switch to
"POWER OFF" with the disc loaded,
remove the battery, and then connect
the AC adapter/charger: Finalize the
disc again.