Advertisement
PRECAUTIO
v --
,.
w
If water should enter the uni~ electrical
shock or malfunction
may
result. Always use it in a place where
there is low humidity and little
dust.
Do not use where there are e~emes
of temperature
(below 5CC or
exceeding 35"C) or where dirad
sunlight
may strike it.
Because of the CD player's
extremely
low noise and wide dynamic
range, there might be a tendency
to set the volume on the amplifier
unnecessarily
high. Doing
so may
produce
an excessively
large
output from the amplifier
which could damage
your speakers.
Sudden changes in the ambient~mperature
may cause condensation
to form on the optical lens inside the unit. If this happens, take out the
disc, leave the unit for about 1 hour, and then proceed to operate.
-
When carrying
the unit, be sufe
to remove
any discs which
may
be inside and turn the power
off. The STANDBY
indicator
lights.
Then unplug the mains
lead from
the AC outlet.
Carrying
the unit
with any discs inside
may dswnage the discs
ancf/or the unit.
The system's speakers use powerful magnets. Do not place timepieces,
credit cards, cassette tapes or video tapes, etc. near the speakers.
Before use
Remove the shipping screw from the rear of the unit as shown in figure.
This screw is used to secure the CD mechanism
during shipment
and
should be retained for future use es shown in figure.
Shipping screw
Green arrow
Before transportation
1.
Turn on the power and remove
all discs from the unit.
2.
Turn the power off. The STANDBY
indicator
I@%.
3.
Then unplug the mains lead from the AC outlet.
4.
Reinstall the shipping screw as shown in figure.
IMPORTANT
If thw plug supplied
with this equipment
is not suitable for the socket
outiids
in your home it should be cut off and replaced with the correct
type.
Dfsgposal of Plug
If tf%e non rewireable
plug is to be cut off, the removed plug should be
disposed
of carefully
as there is a shock hazard should the plug be
insawted into a live socket.
Rep4acing
Fuse
Thr%detachable
fuse cover must be replaced after changing the fuse.
Or@v a 3A fuse should be used and should comply with 6S1362 and
shwld
carry the ASTA mark @.
The
wires in the mains lead are coloured
in accordance
with the
folfmwing code;
Blue
Neutral
Brown
Live
The wires in the mains lead must be connected
to the terminals in the
plmg as follows;
Wire co[our
Plug terminal
marking
Blue
N or Black or Blue
Brown
L or Red or Brown
W
not connect either wire to the earth terminal.
Mtie
mains plug contains a fuse this should be 3A, if a plug without a
fuse is used the distribution
board fuse should not be greater than 5A.
Thre unit is not d=onnected
from the mains unless it is unplugged from
the AC outlet.
>
D@ not install tt'rki equipment
in a confined space, such as a book case
orr built in cabinet.
2
Advertisement
