Before Operation - Sanyo DC-D40 Instruction Manual

BEFORE OPERATION
Turning the power on and off
Press the POWER button. The displays light and the STANDBY indicator
goes out.
To turn off the power, press the POWER button again. The STANDBY
indicator lights.
When the mains lead is connected to the AC outlet, the STANDBY
indicator lights and the unit will respond to commands from the
remote control.
Selecting the function
Press the FUNCTION button to light the desired function indicator.
The function is automatically selected when CD play or tape playback is
started, or when the BAND button has been pressed.
- When the function selection is changed, CD play, tape playback or
recording is automatically stopped (except during tape dubbing).
Adjusting the volume
Turn the VOLUME control or press the "+" or " -" VOL control on the
remote control.
Adjusting the left/right speaker balance
Use the BAIANCE CONTROL to adjust the Iefthight speaker balance.
Bass expander system
Press the BASSXPANDER button to ON to enhance the bass sound.
Selecting the sound mode
Press the SOUND PRESET button to light the sound mode indicator
matching the music to be listened to.
POP: Pops, etc.
ROCK: Rock music. etc.
JAZZ: Jazz, etc.
CLASSIC: Classical music, etc.
If the DEMO button is pressed, the sound mode changes each 10
seconds as follows:
POP -- ROCK -- JAZZ -- CLASSIC -- POP -----
The operating indicator blinks. To cancel this mode, press the DEMO
button again.
WHAT TO DO IF ...
Ifthe operation of the unit or display is not normal or when all the memory
contents are to be cleared, disconnect the mains lead from the AC outlet,
then press the RESET button (rear of the unit) for 20 seconds or more.
COMPACT DISC PREPARATIONS
Use compact discs bearing the symbol shown below. In addition to
conventional 12 cm CDs, this system can be used to play 8 cm CDs with
the 8 cm disc tray.
dr!~
DIGITAL AUDIO
Storing discs in the 10-disc magazine
1. Pull one of the disc trays out of the magazine.
2. Place a disc with the label facing downward on the centre of the disc
tray.
- Do not place a disc with the label facing up, or that disc will not be
played.
3.
4.
RESET
—.
%
Carefully push the disc tray into the magazine until it locks into place.
Repeat steps 1-3 for loading other discs into the magazine.
The disc stored in the lowermost tray is disc number 1. (Observe the
markings on the side of the magazine.)
-5-