Character Display Function - Sony HDCU-950 Installation And Maintenance Manual

3-3. Character Display Function

This unit has the built-in character generation circuit. The
character information such as the settings, state and self-
diagnosis of the unit can be mixed with the HD SDI video
signal and the SD video signal. The mixed signal can be
output from the MONI OUT (DRX-1 board output) and the
PIX OUT (RC-91 board output) connector respectively.
They can be displayed on the HD monitor and the SD
analog monitor.
The character MIX function can be forcibly turned OFF by
turning OFF S206-4 (HD SDI) on the DRX-1 board or
S10-8 (SD SDI) on the RC-91 board.
Operating procedure
In order to show the setting, the state and the self-diagnosis
display on the HD monitor and the SD analog monitor,
press the CHARACTER button of the RCP so that the
button lights, or operate the CHARACTER switch on the
panel surface of the DRX-1 board.
To change the page, press the CHARACTER button of the
RCP. The page can also be changed by pressing the
CHARACTER switch on the panel surface of the DRX-1
board panel.
When the CHARACTER button of the RCP (or CHAR-
ACTER switch on the panel surface of the DRX-1 board)
is kept pressed, the pages are changed continuously. After
all the pages are displayed, the cycling display stops on the
final page and the CHARACTER button of the RCP goes
off. To display the character information again, press the
CHARACTER button of the RCP.
n
The first page is blank. When selecting the first page, the
display of characters is OFF.
S206
CHARACTER switch
HDCU-950 IMM
S203
DRX-1 board (A side/panel side)
The contents of the pages displayed on the HD monitor (or
SD analog monitor) are as follows.
Page Title
0 Displays OFF (CHARACTER button
OFF)
1 Camera Lens/Filter Status
2 Camera Status
3 System Status
4 Diagnosis
5 System Diag 1/3
6 System Diag 2/3
7 System Diag 3/3
8 AT Diag
9 AVP Diag
10 DTX Diag
11 DRX Diag
12-1 Slot-5 Diag (RC-91/DIF-124 Board)
12-2 Slot-5 Diag (FC-88/SDI-73 Board)
13-1 Slot-6 Diag (EN-145/VDA-61 Board)
13-2 Slot-6 Diag (RC-91/DIF-124 Board)
14 ROM Version
Required equipment
. HD monitor
Sony BVM-D20F1J or equivalent
. SD monitor
Sony BVM-1911/2811 or equivalent
. Remote control unit
Sony RCP-700 series
. HDVS camera system
HDC-950/930
3-3. Character Display Function
S10
RC-91 board (A side)
3-3 (E)