Table of Contents
Advertisement
Page 12-1
Slot-5 Diag Dispaly
Displays the details of self-diagnosis of the RC-91 board
when it is mounted in the fifth slot from the left on the
front side of the unit.
* Slot-5 Diag *
Front: RC
1
Squeeze
2
PLD V1.00 Config Done
3
Mode
Normal
4
Rear: DIF
5
Output-A
SD SDI
6
Output-B
SD SDI
No.
Contents
1
Displays the aspect ratio conversion mode during down-
conversion.
2
Displays the state of the PLD (IC301 and IC504 on the
RC-91 board) version and PLD. (Config Done/Config NG)
Config Done : PLD (IC301 and IC504 on the RC-91
board) started correctly.
Config NG :
PLD (IC301 and IC504 on the RC-91
board) did not start correctly.
3
State of the operation mode on the RC-91 board (Normal/
Test)
4
Displays when the DIF-124 board is installed in the rear
correctly.
5
Displays the type of signal that is output from the SD SDI
*8
OUT1 connector on the rear panel. (SD SDI/VBS)
6
Displays the type of signal that is output from the SD SDI
OUT2 connector on the rear panel. (SD SDI/VBS/MONI
*9
SDI)
*8 : When the HKCU-951 is installed, set the switch with S103 on the EN-
145 board. When the HKCU-951 is not installed, the switch is fixed to
SD SDI.
For details, refer to Section 1-6-7. “Setting of Switches on Boards _ EN-
145 Board”.
*9 : When S10-1 on the RC-91 board and the HKCU-951 are installed, set
the switch with S104 on the EN-145 board.
For details, refer to Sections 1-6-6 and 1-6-7. “Setting of Switches on
Boards _ RC-91 Board and EN-145 Board”.
3-3. Character Display Function
Page 12-2
Slot-5 Diag Dispaly
Displays the details of self-diagnosis of the FC-88 board
when it is mounted in the fifth slot from the left on the
front side of the unit.
* Slot-5 Diag *
Front: FC
1
IN
:1080/59.94I
2
OUT :1080/59.94I
3
PLD V1.00 Config Done
4
Mode
Normal
5
Sub-Ref:HD 23.97i
6
Rear: SDI
No.
Contents
1
State of the MAIN INPUT signal format of the frame
converter
2
State of the conversion format of the frame converter
MAIN OUTPUT signal
3
Displays the state of the PLD (IC301 on the FC-88 board)
version and PLD. (Config Done/Config NG)
Config Done : PLD (IC301 on the FC-88 board) started
correctly.
Config NG :
PLD (IC301 on the FC-88 board) did not
start correctly.
4
State of the operation mode on the FC-88 board (Normal/
Test)
5
Displays the signal format of the reference signal that is
input to the FRAME REF IN connector (Sub-Ref) on the
rear panel (with HKCU-953).
6
Displays when the SDI-73 board is installed in the rear
correctly.
3-9 (E)
- Quick Links:
- Connector Input/Output Signal
Hide quick links:
Advertisement
Table of Contents
