Sony HDCU-950 Installation And Maintenance Manual page 67

Setting the Frame Frequency Conversion
When the HKCU-953 is installed and the operation frame
frequency of the camera is set to 24F (24PsF), set the
frame frequency conversion of the return signal.
Setup switch : S606 on the DTX-1 board
(Factory setting : All OFF)
S606-1, -2 : RET 1
S606-3, -4 : RET 2
S606-5, -6 : RET 3
S606-7, -8 : PROMPTER (RET 4)
S603-1, -3, S603-2, -4,
-5, -7 -6, -8
ON ON
OFF ON
ON OFF
OFF OFF
Setup switch : S610 on the DTX-1 board
(Factory setting : 0)
You can set phase of the frame frequency conversion
manually. For details, refer to Section 1-6-5. "Setting of
Switches on Boards _ DTX-1 Board".
HDCU-950 IMM
Type of the frame
conversion
THROUGH :
Frame frequency is not
converted.
A (24PsF conversion) :
When the camera is 24PsF,
the forced-reverse conversion
is performed. (Conversion to
reconstruct 24PsF)
B (48i conversion) :
When the camera is 24PsF,
the forced-reverse conversion
is perfomed. (Conversion to
48i format by simple skipping)
AUTO :
Depends on the setting of
S1-1 on the FC-88 board.
2-5. Video Signal System
2-25 (E)