Acpi Setting - Supermicro Supero 7037A-I User Manual

S W
uper orkstation 7037A-I User's Manual
CPU 1 Temperature/CPU 2 Temperature
The CPU Temperature feature will display the CPU temperature status as detected
by the BIOS:
Low - This level is considered as the 'normal' operating state. The CPU temperature
is well below the CPU 'Temperature Tolerance'. The motherboard fans and CPU will
run normally as confi gured in the BIOS (Fan Speed Control).
Medium - The processor is running warmer. This is a 'precautionary' level and gen-
erally means that there may be factors contributing to this condition , but the CPU
is still within its normal operating state and below the CPU 'Temperature Tolerance'.
The motherboard fans and CPU will run normally as confi gured in the BIOS. The
fans may adjust to a faster speed depending on the Fan Speed Control settings.
High - The processor is running hot. This is a 'caution' level since the CPU's 'Tem-
perature Tolerance' has been reached (or has been exceeded) and may activate
an overheat alarm. The system may shut down if it continues for a long period to
prevent damage to the CPU. If the system buzzer and Overheat LED has activated,
take action immediately by checking the system fans, chassis ventilation and room
temperature to correct any problems.
System Temperature
System temperature will be displayed as detected by the BIOS.
Fan Speed Rating
This feature displays the fan speed readings from Fan 1~Fan 6 and Fan A.
Voltage Readings
The following voltage readings will be displayed.
CPU1 Vcore, CPU2 Vcore, CPU1 VDIMM, CPU2 VDIMM, 1.1V, 1.5V, 5V, SVSB,
12V, -12V, 3.3V, 3.3VSB, and VBAT

ACPI Setting

Use this feature to confi gure Advanced Confi guration and Power Interface (ACPI)
power management settings for your system.
ACPI Sleep State
Use this feature to select the ACPI State when the system is in sleep mode. Select
S1 (CPU_Stop_Clock) to erase all CPU caches and stop executing instructions.
Power to the CPU(s) and RAM is maintained, but RAM is refreshed. Select Suspend
to use power-reduced mode. Power will only be supplied to limited components
(such as RAMs) to maintain the most critical functions of the system. The options
are S1 (CPU_Stop_Clock), Suspend Disabled, and S3 (Suspend to RAM).
7-18