Kranzle 602 E-M 18 Operating Manual page 19

Thermostat - Percentage mode
The innovative new percentage mode now lets the user specify the switching duration
of the heater in percent using the "+" and "-" buttons (Pos. 5+6) (100% being the max.
temperature) rather than setting the desired temperature. Now the result of the setting
must be checked by using the "Actual" temperature display. If the desired temperature has
not yet been reached, the percentage must be increased.
By setting percentages of the heating duration, the temperature of the high pressure jet is
kept constant in a very narrow range.
The last value set is also saved after the unit is switched off in percent mode.
Operating hour meter
The cleaner is equipped with an operating hour meter.
If during normal operation the momentary operating mode button ( "°C" or "%" ) is actuated for
more then 2 seconds, the operating time of the pump is displayed for 5 seconds and afterwards the
combustion time for 5 seconds as well. Thereafter the display shows the original values again.
As long as the operating hours are displayed no further inputs on the monitor are possible.
The operating time is displayed in hours [ h ] either in the "TARGET" or in the „ACTUAL"
window. The 1000 and 100 hours are displayed in the „TARGET" window and the 10, 1 and
1/10 hours in the "ACTUAL" window:
Pump operating time: Target-Display: P 9 9 Actual-Display: 9 9. 9
Combustion time: Target-Display: F 9 9 Actual-Display: 9 9. 9
e.g.: F00 27.3 = Cumbustion time 27 hours and 18 minutes
Displayed malfunctions
Anzeige im Feld
SOLL IST
Err OFF
AUS E7
Err E2
Ursache
Wassertemperatur am
Ausgang der Heizelemente
über 147 °C
Gerät wurde länger als 20
Minuten nicht betrieben
-> Sicherheitsabschaltung
Temperatursensor defekt
Abhilfe
Gerät ohne Heizung „Heizung AUS"
so lange betreiben, bis die Temperatur
wieder unter 147°C gefallen ist.
Hauptschalter „AUS" und wieder „EIN"
schalten
Hauptschalter „AUS" und wieder „EIN"
.
schalten
Temperatursensor ersetzen
19
for 9 999.9h
for 9 999.9h