Eneo FASTRAX III Instruction Manual page 35

• DATA MANAGEMENT
BACKUP
RESTORE
NOTE: BACKUP/RESTORE functions can not be applied according to the version of the dome base board.
FACTORY DEFAULT
Select the Factory Default to initialize the Data.
ERASE PROGRAMMED DATA
Erase all stored data from the Flash-ROM of the selected dome camera. You will be asked to enter
ON or OFF. If you desire to erase all data then select the Erase Run, otherwise press the ESC key to
exit without erasing. The erased data includes all
stored data (auto scan, presets, and tours....) except origin offset.
The offset value is still valid after all data is erased. The offset value can be zero with default set of
Offset origin menu.
DATA MANAGEMENT
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
BACKUP
RESTORE
EXIT (ESC TO CANCEL)
; Upload dome configuration data to the dome base.
; Download dome configuration data from the dome base.
FACTORY DEFAULT
ARE YOU SURE ?
ERASE PROGRAMMED DATA
AUTO SCAN
PRESET
TOUR
PATTERN
ALARM
AREA TITLE
PRIVACY ZONE
CAMERA
DOME SETUP
ERASE
SAVE AND EXIT(ESC TO CANCEL)
CANCEL
OK
: ON
: ON
: ON
: ON
: ON
: ON
: ON
: ON
: ON
29