Table of Contents
Advertisement
NOTE:
To save changes press the [Save] button, the FTP server window will be closed. If you do not want to save
any changes press the [Cancel] button.
11.1.1.3. HTTP
To configure HTTP server go to SETTING – Event – Event Server – Event Server menu
and press the [Add] button to open the configuration window. Then select HTTP as a server type
(Pic. 11.12).
This menu allows you to configure sending of HTTP (CGI) commands to an external alarm
device. This device, in turn, sends a command to another external device or closes relay contacts.
For example, the camera sends an HTTP (CGI) command to the device, which, in turn, closes
relay contacts and triggers an alarm.
The menu contains the following sections: "General" and "Server Setting" (Pic. 11.12).
Name: enter the server name.
Server type: select a server type: FTP, SMTP, HTTP, Network Storage.
URL: enter IP address and a prefix of demanded command (up to 64 symbols).
NOTE:
IP addresses should correspond to the IP address of the device which is used to receive CGI commands.
Port: enter a port of the HTTP server (the default value is 80) from 1 to 65535.
N300 Operations User Manual
Chapter 11. The [SETTING] Menu: Event
Pic. 11.12
72
Advertisement
Table of Contents
