Table of Contents
Advertisement
MBT-4000 Multi-Band Transceiver System
Remote Control
Command
Valid on
Parameter
(Instruction
Type
Code and
BDC, or
qualifier)
Mute offline
OFM=um
MBT
Arguments
MBT,
for Command
(Note that all arguments are ASCII numeric codes – i.e.,
or Response
BUC
to Query
u=1 byte,
Command or Query.
value of 1, 2
This command allows the user to enable muting for offline unit
1=Unit 1
when in redundancy mode.
2=Unit 2
Note: The offline unit must start out as online for this command.
m=1 byte,
Value of 0, 1
Where:
0 = Manual
OFM=10 would be existing behavior for the block in slot 1.
1 = Automatic
OFM=11 would force a mute of the block in slot one if slot one is
offline as indicated by the switch position(blinking yellow or red
LED). It would force an "un- mute" of the block in slot one if slot
one is online and not faulted as indicated by the switch
position(steady green LED).
OFM=20 would be existing behavior for the block in slot two.
OFM=21 would force a mute of the block in slot one if slot two is
offline as indicated by the switch position(blinking yellow or red
LED). It would force an "un- mute" of the block in slot two if slot
two is online and not faulted as indicated by the switch
position(steady green LED).
These settings would be kept in NVRAM and would come from
the factory as "OFM=10" and "OFM=20"
Also, the offline unit must not be muted during this time.
The offline unit has to be set for online, otherwise the OFM
command won't work properly.
Description of Arguments
ASCII codes between 48 and 57)
A–24
Revision 4
MN/MBT4000.IOM
Response to
Query
Command
(Instruction
(Target to
Code and
Controller)
qualifier)
OFM= (message OK)
RAM?u
OFM? (received OK,
but invalid arguments
u=1 byte,
found)
Value of 1, 2
OFM! (command not
accepted
Response to
Query
(Target to
Controller)
RAM=um
(same format as
command
arguments)
Advertisement
Table of Contents
