Table of Contents
Advertisement
MBT-4000 Multi-Band Transceiver System
Flash Upgrading
Double-click FLSHCSAT.EXE
3
(filename or icon) to execute
the flash upload utility.
From the FLSHCSAT
window, select the pertinent
serial port used for
communication between the
user-provided PC and the
4
MBT-4000.
(In this example, as noted at
'A', COM1 has been
selected.)
Do not select a Baud Rate
(noted at 'B') other than the
default selection of 38400,
5
unless otherwise instructed
by Comtech EF Data
Technical Support.
Click on 'Software Upload',
6
as noted at 'C'.
The user is prompted to
select the firmware file to
upload. Click 'Choose File',
then select the file from the
temporary folder created
7
earlier by using the box to the
right to navigate to the
desired folder, then double-
clicking on the firmware file
using the box to the left.
Prior to continuing the upload
process, the MBT-4000
system must be powered off.
8
Disconnect the power cable
from the Base Unit, then click
on 'Start Upload' to resume
the upload process.
5–4
Revision 4
MN/MBT4000.IOM
A
B
C
Advertisement
Table of Contents
