Table of Contents
Advertisement
MBT-4000 Multi-Band Transceiver System
Remote Control
Command
Valid on
Parameter
(Instruction
Type
Code and
BDC, or
qualifier)
Calibrate LNA
CLC=
BDC
Current
Calibrate LNA
CLC=s
MBT
Current
Arguments
MBT,
for Command
(Note that all arguments are ASCII numeric codes – i.e.,
or Response
BUC
to Query
none
Command only.
This command is used to set the calibration point for the LNA
current alarm feature.
Example: CLC=
S=1 byte
Command only.
Value of
This command is used to set the calibration point for the LNA
1 , 2
current alarm feature, where s = Source:
1=LNA A
1=LNA A (AUX COMM1)
2= LNA 2
2=LNA B(AUX COMM2)
Example: CLC=1
Description of Arguments
ASCII codes between 48 and 57)
A–10
Revision 4
MN/MBT4000.IOM
Response to
Query
Command
(Instruction
(Target to
Code and
Controller)
qualifier)
CLC=(message ok)
N/A
CLC?(received ok,
but invalid arguments
found)
CLC*(message ok,
but not permitted in
current mode)
CLC!(command not
accepted by BDC
sub-units.)
CLC=(message ok)
N/A
CLC?(received ok,
but invalid arguments
found)
CLC*(message ok,
but not permitted in
current mode)
CLC!(command not
accepted by BUC or
BDC sub-units.)
Response to
Query
(Target to
Controller)
N/A
N/A
Advertisement
Table of Contents
