3.
USB driver installation is complete.
DSP Configurator Program
Starting the Program
NOTE: Extron recommends connection via the Ethernet LAN port for running the
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP
Configurator.
The DSP Configurator program starts in
Mode vs. Live
Using the Program
In the DSP Configurator window Emulate mode, audio parameters may be selected,
then transferred to the DMP 64 by going to Live mode (while connected to a DMP 64).
Audio settings can also be tailored while connected to the DMP 64 which allows real-time
auditioning of the audio output as adjustments are made. See
Mode, later in this chapter.
Figure 42.
Successful USB Driver Installation
Click
.
Finish
DSP Configurator program.
Mode.)
mode (figure 44). (Refer to
Emulate
Emulate Mode vs. Live
DMP 64 • Software Control
Emulate
82