Extron electronics DMP 64 User Manual page 143

Mute and Unmute Inputs and Outputs
Pressing the mute button toggles mute on and off. When muted, the Mute button is red
and displays . When unmuted it returns to gray and displays
Muted
Mute and umute as follows:
1.
Next to the desired input or output press the
turns red) or off (button is gray).
2.
Repeat for each input and output).
Mute and Unmute the Mixer-points
The HTML mixer does not include control for the virtual bus send and receive mixer. When
a mixer-point is muted (default) no signal passes. When unmuted, the signal passes from
selected input to the selected output.
Mute and unmute the mixer-points as follows:
1.
Click the desired input/output combination. The selected mix-point turns green.
(Mic 1 to Output 4 is shown in figure 73).
Figure 73. Output Selection Drop Box
2. Click the button to either toggle mute on or off.
Mute
3.
Repeat steps 1 and 2 for each I/O combination.
Change the Mic Mix Audio Level
To change the mix-point audio input level:
1.
Click the desired input/output combination. The selected mix-point turns green.
(Mic 1 to Output 4 is shown in figure 73).
2.
Click the
Mic Mix Audio Level
Alternately the + and - boxes increment the level up or down one step.
3. Click and drag the slider or click the scroll up
the desired audio level is visible.
4. Click the desired gain or attenuation value. The range is -35 to +25 dB.
5.
Repeat steps 1-3 for each mix-point.
Mute button to toggle mute on (button
drop box. A drop-down scroll box appears.
button or scroll down
DMP 64 • HTML Operation
.
Mute
button until
137