Furniture Mounting; Table Or Wall Mounting - Extron electronics DMP 64 User Manual

Furniture Mounting

Furniture mount the DMP 64 using the optional mounting kit (Extron MBU 125, part
#70-077-01, under-desk; or Extron MBD 129, part #70-077-02, through-desk) as follows:
1.
Attach the selected mounting brackets with the machine screws provided.
2.
If feet were previously installed on the bottom of the cabinet, remove them.

Table or Wall Mounting

The table or wall mounting brackets extend approximately 1/4 inch (6.4 mm) above the
top surface of the enclosure. This design allows for an air space between the enclosure
and the surface to which it is mounted.
Table or wall mount the DMP 64 as follows:
1. Hold the unit with the attached brackets against the underside of the table or other
furniture, or against the wall. Mark the location of the screw holes of the bracket on
the mounting surface.
2.
Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.4 mm) deep in the mounting
surface at the marked screw locations.
3. Insert #8 wood screws into the four pilot holes. Tighten each screw into the
mounting surface until just less than 1/4 inch of the screw's head protrudes.
4.
Align the mounting screws with the slots in the brackets and place the unit against
the surface, with the screws through the bracket slots.
5.
Slide the unit slightly forward or back, then tighten all four screws to secure it in
place.
Figure 2.
HalfRackDeskMount
MBU 125, Under Desk Mounting
DMP 64 • Installation 7