Group Controls Page - Extron electronics DMP 64 User Manual

Change the Output Volume Level
The output volume attenuates the signal from full volume down to 0 volume in 100 steps.
Users can set individual output volume levels from a range of -100 dB (full attenuation,
minimum volume) to 0 dB (no attenuation, full volume).
Change an output audio level setting as follows:
1.
Next to the desired output number, click the
scroll box appears.
2. Click and drag the slider or click the scroll up
the desired audio level is visible.
Alternately the + and - boxes increment the level up or down one step.
3. Click the desired attenuation value. The range is -100 to 0 dB.
4.
Repeat steps 1-3 for each output.

Group Controls Page

If group controls have been set using SIS commands or DSP Configurator, the group
controls page provides access to those controls. Group controls cannot be set using the
HTML pages. Access the group controls page by clicking the
left of the control page.
Figure 74.
To adjust a group control:
1. Next to the desired group control, directly input a value by clicking in the box and
typing a value, or use the + and - box to increment or decrement the value by one.
2.
Repeat step 1 for each group.
NOTE: The range of each group control is displayed under the value box.
Group Controls Page
drop box. A drop-down
output level
button or scroll down
Group Controls
DMP 64 • HTML Operation
button until
link on the
138