Alarms; Silencing An Alarm - Cooper Security i-on 40 Administrator's Manual

2. Alarms

The i-on40 normally starts an alarm when it receives an alarm
signal from one of its detectors. In addition, you can start a panic
alarm from the keypad. The table below shows the different kinds
of alarms possible.
Type of
Alarm (see note)
Intruder Loud warbling
tone from
siren.
Fire Pulsing tone
from siren.
Panic Loud warbling
tone from
siren
Technical Loud warbling
tone from
siren.

Silencing an Alarm

In an alarm the i-on40 operates the sirens. The sirens run for a
limited time set by the installer (a maximum 15 minutes for
intruder and panic alarms).
If you return to the system while the sirens are running you can
silence the siren as follows:
1. Key in your access code (or
present your tag to the
keypad)
Page 10
Signal
Normal alarm or entry route zone
activated when system is set.
24 hour zone activated at any time.
Fire zone activated at any time.
PA zone or Panic Alarm transmitter
activated at any time.
(The installer must enable this
feature on your system.)
Technical alarm zone activated at
any time.
Started by:
Pressed on keypad.
i-on40