Zdp Timer; Ztp Enable - Zte ZXR10 Command Manual

ZXR10 Command Manual (Network Management Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Instructions
Example
48 Confidential and Proprietary Information of ZTE CORPORATION
show zdp

zdp timer

Use this command to set the time interval for sending neighbor
discovery packets. Restore the default value with the no form of
this command.
Global configuration
zdp timer <time>
no zdp timer
<time>
This command is supported after the platform version 4.6.02.
This example describes how to set the time interval for sending
neighbor discovery packets to 160 seconds.
ZXR10(config)#zdp timer 160
show zdp

ztp enable

Use this command to enable topology collection on the switch or
interface (ordinary interface or Smartgroup interface). Disable
topology collection on the switch or interface (ordinary interface
or Smartgroup interface) with the no form of this command.
Global configuration and interface configuration

ztp enable

no ztp enable
This command is supported after the platform version 4.6.02.
�
This example describes how to enable topology collection on
the switch in global configuration mode.
ZXR10(config)#ztp enable
� This example describes how to disable topology collection on
the interface gei_1/4 in interface configuration mode.
ZXR10(config)#interface gei_1/4
ZXR10(config-if)#no ztp enable
Time interval for sending neighbor discovery
packets, in seconds, range: 5~254, default:
30 seconds