Toshiba E-Studio 557 Manual page 13

Message
Cannot copy
Check DEPARTMENT
COUNTER
Add paper
Call for service
Examine stapler in the Saddle
Stitch unit
Check staple cartridge in the
Saddle Stitch unit
Check staple cartridge
Examine Stapler
Saving energy - press START
button.
CHANGE DRAWER TO
CORRECT PAPER SIZE
Time for periodic maintenance The equipment requires
POWER FAILURE
Problem Description
The number of originals to be
scanned has exceeded the
limit specified with the
department code during
scanning.
No paper is left in a drawer or
on the bypass tray.
The equipment requires
adjusting by a service
technician.
Staple jam has occurred in the
stapler of the saddle stitch
unit.
No staples are left in the
stapler of the saddle stitch
unit.
No staples are left in the
stapler of the finisher.
Staple jam has occurred in the
stapler of the finisher.
The equipment has entered
into the energy saving mode
since it has not been used for
a certain time.
No paper suitable for the
original is set.
The size of the original is not
detected correctly because
the original is sent from the
Reversing Automatic
Document Feeder at a skew.
inspection and maintenance
by a service technician.
A job was interrupted by a
power failure or some other
reason.
1 TROUBLESHOOTING FOR THE HARDWARE
Corrective Action
Ask your administrator for details of setting
the limit for the number of copies.
Set paper in the drawer or on the bypass
tray. The touch panel indicates which
drawer (or the bypass tray) has no paper.
To set paper, refer to the Copying Guide.
Contact your service representative with
the error code displayed on the right side of
the touch panel.
Never attempt to repair, disassemble or
modify the equipment by yourself.
You could cause a fire or get an electric
shock.
Always contact your service representative
for maintenance or repair of the internal
parts of the equipment.
Remove the jammed staples.
 P.38 "Staple jam in the saddle stitch
unit"
Refill the staples.
 P.47 "Refilling With Staples"
Refill the staples.
 P.47 "Refilling With Staples"
Remove the jammed staples.
 P.35 "Clearing a Staple Jam"
Press any of the [START], [COPY],
[e-FILING], [SCAN], [PRINT], [FAX] and
[ENERGY SAVER] buttons to clear the
energy saving mode.
Place the suitable size paper for the
original in the drawer.
Replace the original while aligning the side
guides of the Reversing Automatic
Document Feeder to its width so that it will
be placed straight.
If you do not want the equipment strictly to
distinguish A4 and LT, or A3 and LD at the
scanning of the original, contact your
service technician or service
representative.
Contact your service representative for
maintenance.
The print or fax job may be incomplete.
Press [JOB STATUS] to check whether any
jobs are unfinished.
To clear the messages, press the
[FUNCTION CLEAR] button twice.
Messages Displayed on the Touch Panel 11