Static Mac Address - Planet FGSW-2620VM User Manual

OObject Description
Input a group ID and available range is 1-255.
Group id
To assign "Permit" or "Deny" for Access Control List.
Action
To choose VLAN type as "Any" or by "VID (1-4094)".
VLAN
To choose Packet type as "IPv4" or by "Non-IPv4".
Packet Type
To decide to "check" or "Uncheck" the IP fragment.
IP Fragment
Provide additional L4 protocol for security on Layer 4 level.
L4 Protocol
Display "IPv4" or "Non-IPv4" ACL groups, maximum up to 16 groups.
Current List
Press this button for add Access Control List group on the Switch.
Add button
Press this button for delete Access Control List group on theSwitch.
Del button

4.5.3 Static MAC Address

When you add a static MAC address, it remains in the switch's address table, regardless of whether the device is
physically connected to the switch. This saves the switch from having to re-learn a device's MAC address when the
disconnected or powered-off device is active on the network again.
To bind the MAC Address, click on the Security/ Static MAC Address menu button, the main web page then shows the
Static MAC Address function table.
Fill the MAC Address field with MAC address in the format "xx-xx-xx-xx-xx-xx "
1.
Choose the port to bind the MAC Address in the Port field.
2.
Click on the "Add" button.
3.
Figure 4-5-4 Access Control List (ACL) Web Page screen
FGSW-2620VM User's Manual
65