Per Port Configuration - Planet FGSW-2620VM User Manual

4.3.2.2 Per Port Configuration

You can configure path cost and priority of every port.
OObject
Port
Path cost
Priority
Admin P2P
Admin Edge
Admin Non Stp
Apply button
Figure 4-3-7 SPT - Per Port Configuration interface
Description
The cost of the path to the other bridge from this transmitting bridge at the specified
port. Enter a number 1 through 200000000.
Decide which port should be blocked by priority in LAN. Enter a number 0 through
240 in steps of 16.
Some of the rapid state transactions that are possible within RSTP are dependent
upon whether the Port concerned can only be connected to exactly one other
Bridge(ie., it is served by a point-to-point LAN segment), or can be connected to
two or more Bridges(i.e., it is served by a shared medium LAN segment). The
adminPointToPointMAC allow the p2p status of the link to be manipulated
adminitratively.
Present in implementations that support the identification of edge ports. All ports
directly connected to end stations cannot create bridging loops in the network and
can thus directly transition to forwarding, skipping the listening and learning stages.
If true, this port will not participate in RSTP.
Press the button to save the modification.
FGSW-2620VM User's Manual
48