Install The Switch; Desktop Installation; Rack Mounting - Planet FGSW-2620VM User Manual

24-port 10/100mbps with 2g tp/sfp combo managed ethernet switch

Table of Contents

Power Notice:

The device is a power-required device, it means, it will not work till it is powered. If your networks should active all

the time, please consider using UPS (Uninterrupted Power Supply) for your device. It will prevent you from network

data loss or network downtime.

In some area, installing a surge suppression device may also help to protect your switch from being damaged by

unregulated surge or current to the Switch or the power adapter.

2.2 Install the Switch

This section describes how to install the Ethernet Switch and make connections to it. Please read the following topics

and perform the procedures in the order being presented.

To install the Switch on desktop or shelf, please follows these steps:

Step1: Attach the rubber feet to the recessed areas on the bottom of the switch.

Step2: Place the switch on the desktop or the shelf near an AC power source.

Step3: Keep enough ventilation space between the switch and the surrounding objects.

Note

When choosing a location, please keep in mind the environmental restrictions discussed in Chapter 1,

Section 4, in Specification.

Step4: Connect the Switch to network devices.

A. Connect one end of a standard network cable to the 10/100/1000 RJ-45 ports on the front of the Switch

B. Connect the other end of the cable to the network devices such as printer servers, workstations or routers...etc.

Connection to the Switch requires UTP Category 5 network cabling with RJ-45 tips. For more information,

Note

please see the Cabling Specification in Appendix A.

Step5: Supply power to the switch.

A. Connect one end of the power cable to the switch.

B. Connect the power plug of the power cable to a standard wall outlet.

When the switch receives power, the Power LED should remain solid Green.

To install the switch in a 19-inch standard rack, please follows the instructions described below.

Step1: Place the switch on a hard flat surface, with the front panel positioned towards the front side.

Step2: Attach the rack-mount bracket to each side of the switch with supplied screws attached to the package.

Figure 2-2 FGSW-2620VM rear panel.

FGSW-2620VM User's Manual

Table of Contents