3. DISASSEMBLY AND REASSEMBLY
3.
Gently remove the wire from the wire holder before removing the Power Switch Block. Slide
the Power switch Block in the direction shown. The Power Switch Block can then be
removed from the Cover Bottom.
4.
Turn the Cover Bottom around with the base facing upwards and release the Cable Holder
by removing a 3X8 p-tite screw. Remove the two 3X8 p-tite screws to release the Water
Guide from the Cover Bottom. Lift the Water Guide to remove it from the Cover Bottom.
Cable Holder
Cover Bottom
3.3
REASSEMBLE PROCEDURE
Reassemble each part in the reverse order of the disassembly procedure described in Sections 3.2
and 3.3.
3x8 p-tite screws
3-11
EO18-13005
3.3 REASSEMBLE PROCEDURE
Wire removed
Water Guide