Set Up Procedure; Requirements For Operation - Toshiba TRST-A10 Owner's Manual

4. SET UP PROCEDURE

4.1 Requirements for Operation

This printer has the following requirements:
Serial interface Type
•
The TOSHIBA POS terminal to be connected must have a serial port.
•
To communicate with the TOSHIBA POS terminal, an RS-232C interface cable is required.
RS-232C cable....... 9 pins
USB Interface Type
•
The TOSHIBA POS terminal to be connected must have a USB port.
•
To communicate with the TOSHIBA POS terminal, a USB cable is required.
Parallel Interface Type (Option)
•
The Toshiba POS terminal to be connected must have a Centronics parallel port.
•
To communicate with the Tohsiba POS terminal, a Centronics interface cable is required.
Centronics cable ...... 36 pins.
Interface Cables
For the serial interface model, use the RS-232C cable which satisfies the following pin configuration
and the specification of the connector. For the USB interface model, use the USB cable which satisfies
the following pin configuration and the specification of the connector. For the Parallel interface model
(Option), use the USB cable which satisfies the following pin configuration and the specification of the
connector.
To prevent the emission and receipt of electrical noise, the interface cable must meet the following
requirements:
•
Fully shielded and fitted with metal or metalized connector housings.
•
Kept as short as possible.
•
Should not be tightly bundled with the power cord.
•
Should not be tied to power line conduits.
TOSHIBA TEC Europe Retail Information Systems
Owner's Manual TRST-A10 Page 15 of 32 2007-03-14