Periodic Maintenance; Periodic Maintenance Procedure - Toshiba TRST-A10 SERIES Maintenance Manual

8. PERIODIC MAINTENANCE

8. PERIODIC MAINTENANCE
To retain the quality and performance of this machine and to prevent unexpected troubles, the following
maintenance should be performed periodically.
8.1

PERIODIC MAINTENANCE PROCEDURE

Be sure to perform the following cleaning and checks every six months.
No. Check item
Appearance check
1
Cleaning the covers
2
Cleaning the print head
3
Cleaning the cutter and
4 sensors
Cleaning the inside of
5 the printer
6 Platen check
Print check
7
Procedure/check point
Visually check the outside of the unit for
any deformation, cracks, clearance, or
bend.
Wipe the covers with a soft dry cloth or
soft cloth slightly moistened with mild
detergent. After using detergent for
cleaning, be sure to wipe it off with a
moistened cloth.
Clean the print head with a cotton swab
slightly
moistened with alcohol.
Remove any dust and paper particles from
the cutter, and from the sensors with an air
blower or a brush.
Remove any dust or paper particles from
the inside of the printer with an air blower
or a brush.
Check if the platen is stained or damaged.
Perform a print quality test with the self
test print.
8-1
8.1 PERIODIC MAINTENANCE PROCEDURE
Required tool
Soft dry cloth or soft
cloth slightly
moistened with mild
detergent
Cotton swab slightly
moistened with
alcohol.
• Air blower
• Brush
• Air blower
• Brush
Refer to Page 5-1
EO18-13005
-----
-----