Power Saver Mode; Exiting The Power Saver Mode - Fuji Xerox DocuPrint P255 d User Manual

Power Saver Mode

The printer has a power saving feature that reduces power consumption during periods of inactivity
and operates in two modes: Low Power and Sleep. In Low Power mode, only the LCD panel goes
blank. In Sleep mode, all LEDs, except for the
and the LCD panel goes blank. When the printer is in Sleep mode, it consumes less power than in
Low Power mode.
By default, the printer enters Low Power mode in one minute of inactivity after completion of the last
print job, and then enters Sleep mode in another six minutes of inactivity. You can change these
default settings in the following ranges:
Low Power mode: 1 to 30 minutes
Sleep mode: 6 to 11 minutes
See also:
• "Changing the Power Saver Mode Settings" on page 187
 Exiting the Power Saver Mode
The printer automatically exits the power saver mode when it receives a print job from a computer.
Alternatively, you can manually bring it back to the ready-to-print state by pressing the
Saver) button. Whether the printer is in Low Power or Sleep mode, it will take about 25 seconds for
the printer to resume the ready-to-print state.
NOTE:
• In Low Power mode, opening and closing the rear cover will bring the printer back to the ready-to-print state.
• When the printer is in Sleep mode, all buttons on the operator panel except for the
do not function. To use the buttons on the operator panel, press the
power saver mode.
See also:
• "Changing the Power Saver Mode Settings" on page 187
(Energy Saver) LED, on the operator panel go out
(Energy Saver) button to exit the
(Energy
(Energy Saver) button
Basic Operation 37