Covers - Stairmaster MOMENTUM 3400 CE Owner's Manual

•
PARTS REMOVAL
~ND
REPLACEMENT
COVERS
.&.w-.-I
TO REDUCE THE RISK OF INJURY. DO NOT OPERATE THE MACHINE
WHILE THE COVERS ARE REMOVED. DO NOT ROTATE THE PEDALS WHILE
ANYONE'S HANDS ARE INSIDE THE MACHINE.
The Momentum 3400 CE / 3800 RC cycle ergometer is protected by two large
side covers.
1. If connected, disconnect the battery charger from the connector located
on the back right side cover.
Washer
/
2X25533
Screw
/2,25534
\\~
....
~
left coyer
as3eniJly
25654
Nut
2x 25532
Right
coyer
as3embly
2~53
Use a phillips screwdriver to remove the screws, washers, and nuts
from the side covers by the seat post.
Main frarre
2.
•
•
3.
The side covers are held in place with seven reusable fasteners. Use the
fastener removal tool (included with each machine) to remove the
fasteners. Slide either end of the fastener
~emoval
tool under the edge
of the inner head pin and pull the pin out about halfway. The inner head
pin should not be pulled out of its base. Remove the fastener from the
cover and set aside.
Page 49