Measured Propagation Delays - Basler Camera User Manual

AW00123402000

5.10.3 Measured Propagation Delays

The propagation delays reported in this section (see
minimum values related to "slow" edges.
The values relate to the specific camera operating conditions listed below and are based on a
camera production lot of 2000 cameras. No inferences can be drawn on propagation delays
resulting from different operating conditions.
The measured propagation delays apply only to the following operating conditions:
Housing temperature: +25 °C.

Load resistance: R

I/O supply voltage: U

Opto-isolated input
Direct-coupled GPIO IN
Table 13: Propagation Delays for the Camera Inputs (+25 °C, R
Opto-isolated output
Direct-coupled GPIO OUT
Table 14: Propagation Delays for the Camera Outputs (+25 °C, R
Transition Threshold = 2.0 V)
For the graphical illustration of propagation delays, see
Basler ace USB 3.0
= 170 Ω
L
= 5 VDC
S
Propagation Delays for Inputs
Fast Edge
4.5 - 7.5 µs (rising edge)
< 0.5 µs (falling edge)
Propagation Delays for Outputs
Fast Edge
3 - 6 µs (falling edge)
< 0.5 µs (falling edge)
Table 13 and Table 14) are likely to be near-
Slow Edge
19 - 28 µs
< 1 µs
= 170 Ω, U
= 5 VDC)
L S
Slow Edge
27 - 38 µs
< 2.5 µs
= 170 Ω, U
= 5 VDC,
L S
Figure 37 and Figure
Physical Interface
(falling edge)
(rising edge)
(rising edge)
(rising edge)
38.
63