Basler Camera User Manual page 42

Specifications, Requirements, and Precautions
NOTICE
Using a wrong pin assignment can severely damage the camera:
Make sure the cable and plug you connect to the 6-pin I/O connector follow the correct pin

assignment.
Warranty Precautions
To ensure that your warranty remains in force:
Do not remove the camera's serial number label
If the label is removed and the serial number can't be read from the camera's registers, the warranty
is void.
Do not open the camera housing
Do not open the housing. Touching internal components may damage them.
Keep foreign matter outside of the camera
Be careful not to allow liquid, flammable, or metallic material inside of the camera housing. If
operated with any foreign matter inside, the camera may fail or cause a fire. For the special case of
cleaning the camera's sensor, see the instructions below.
Avoid electromagnetic fields
Do not operate the camera in the vicinity of strong electromagnetic fields. Avoid electrostatic
charging.
Transport properly
Transport the camera in its original packaging only. Do not discard the packaging.
Clean properly
Note:
Before starting the cleaning procedure, cut off all power to the camera by unplugging the plugs

from the USB 3.0 Micro-B port and from the 6-pin I/O connector.
Make sure all window cleaner or detergent has vaporized after the cleaning procedure, before

reconnecting the plugs.
Avoid cleaning the surface of the camera's sensor, if possible. If you must clean it, use a soft, lint
free cloth dampened with a small quantity of high quality window cleaner. Because electrostatic
discharge can damage the sensor, you must use a cloth that will not generate static during cleaning
(cotton is a good choice).
To clean the surface of the camera housing, use a soft, dry cloth. To remove severe stains, use a
soft cloth dampened with a small quantity of neutral detergent, then wipe dry.
32
AW00123402000
Basler ace USB 3.0