Remote Access With Qt/Dqt; Clear To Transpond - Kenwood TKR-750-850 Function Reference

18.3 Remote Access with QT/DQT

Using the QT/DQT code, you can permit TKR-750/850/
751/851 to receive the Air-Remote code.
You can configure the Reception function for the Air
Remote code corresponding to the match/unmatch status
of the QT/DQT code by KPG-91D.
! Configuration of KPG-91D
" Configure the Reception function for the Air
Remote code with the match/unmatch status of the
QT/DQT: (Refer to 5 QT/DQT.)
Note:
# This function is available only to receive an Air Remote
code. This function does not affect the repeat operation.
# When TKR-750/850/751/851 is configured to receive the Air
Remote code only when the QT/DQT matches, the QT/DQT
Decode function works to receive the Air Remote code even
when the QT/DQT Decode function is disabled like following
• When the Off-hook Decode is disabled and the
microphone is on Off-hook position.
• When the monitor is switched On:

18.4 Clear to Transpond

The Clear to Transpond is a function to wait to transmit a
Transpond code until the channel becomes available.
! Configuration of KPG-91D
" Configuring the Clear to Transpond (Air Remote)
(Refer to FPRG 6.9.2 "AUX Input/Output" tab.)
Version: 1.01 USA Function Reference (FUNC)
18 REMOTE CONTROL
42