Table of Contents
Advertisement
18 REMOTE CONTROL
# Although you can configure three functions (1st, 2nd and 3rd) to
the Auxiliary Input port, you can activate only the 1st function by
Air Remote.
(Refer to 20 Function Port.)
# You cannot configure this function that TKR-750/850/751/851
would not accept, such as the Channel Up function.
! Configuration of KPG-91D
" Configuring the Aux Input Deactivation (Refer to
FPRG 6.9.2 "AUX Input/Output" tab.)
18.2.3 Aux Output Activation
This function is to transmit an Air Remote code when the
function assigned to the Auxiliary Input port is activated.
When no function is assigned to an Auxiliary Output port,
you can control external devices by specifying a Decode
code.
Note:
# You cannot use this function for TX Unlock and TXS.
# Although you can use the RF Power Down Detect with the Air
Remote, the Air Remote code is sent with the low transmission
power.
! Configuration of KPG-91D
" Configuring the Aux Output Activation (Refer to
FPRG 6.9.2 "AUX Input/Output" tab.)
18.2.4 Aux Output Deactivation
This function is to transmit the Air Remote code when the
function assigned to an Auxiliary Input port is disabled.
When no function is assigned to an Auxiliary Output port,
you can control external devices by specifying the
Decode code.
Note: You cannot use this function for TX Unlock and TXS.
! Configuration of KPG-91D
" Configuring the Aux Output Deactivation (Refer to
FPRG 6.9.2 "AUX Input/Output" tab.)
18.2.5 Aux In/Out Transpond
This function notifies the transmitting party that TKR-750/
850/751/851 accepts an Air remote code for Auxiliary I/O.
(Refer to 19 Transpond.)
41
It is possible to select a timing to transmit Transpond
code within "Before", "After" or "both"
Also it is possible to configure a transpond code to
activate/deactivate each other by FPU.
Aux Transpond Activation
TKR-750/850/751/851 transmits a Transpond code when
the function assigned to the Auxiliary port activates by the
Air Remote.
Aux Transpond Deactivation
TKR-750/850/751/851 transmits a Transpond code when
the function assigned to the Auxiliary port disables by the
Air Remote.
You can use a Single Tone as the Transpond code when
the DTMF signalling is configured.
Tone for the PF Key Transponder.)
! Configuration of KPG-91D
" Configuring the Aux In/Out Transpond function
(Refer to FPRG 6.9.2 "AUX Input/Output" tab.)
" Configuring the Aux Transpond Activation (Refer
to FPRG 6.9.2 "AUX Input/Output" tab.)
" Configuring the Aux Transpond Deactivation
(Refer to FPRG 6.9.2 "AUX Input/Output" tab.)
18.2.6 Single Tone for the Aux
You can select DTMF or Single Tone as the Transpond
code when the DTMF signalling is configured.
! Configuration of KPG-91D
" Configuring the Single Tone of the Aux
Transponder (Refer to FPRG 6.9.2 "Aux Input/
Output" tab.)
Note: You cannot individually select DTMF/Single Tone for
Function Reference (FUNC)
(Refer to 18.1.4 Single
Transponder function
Aux Transpond Activation and Deactivation.
Version: 1.01 USA
Advertisement
Table of Contents
