Table of Contents
Advertisement
25 PROGRAM
Firmware Programming Mode is a mode to write software
to the flash memory. TKR-750/850/751/851 enters this
mode press and hold the PF [1] key while turning TKR-
750/850/751/851 ON. In this case, the 7-segment LED of
the Channel/Status display lights "P.G.".
Display.)
The default baud rate to communicate with the computer
is 115200 bps. You can change the baud rate by pressing
the PF [1] key.
(Refer to 1.5 Mode.)
115200 bps
38400 bps
The display of the Channel/Status display changes when
the baud rate changes.
•
Two dots light. (P.G.): 115200 bps, DG-binary format
•
One dot lights (P G.): 57600 bps, DG-binary format
•
Dots do not light (P G): 38400 bps, DG-binary format
You can write data to the flash ROM using the special
software (FPRO.EXE). The TX LED lights red when the
data is correctly written into the flash ROM. The BUSY
LED lights green when an error occurs while writing data
to the flash ROM.
62
(Refer to 1.6
57600 bps
Function Reference (FUNC)
Version: 1.01 USA
Advertisement
Table of Contents
