Reversing The Picture Orientation (Vertically And Horizontally) (Using The Bkdw-704 Extension Board) (Dvw-709Ws/709Wsp/790Ws/790Wsp Only) - Sony Digital betacam DVW-707 Operation Manual

3-2-4 Reversing the picture orientation
(vertically and horizontally) (Using the
BKDW-704 Extension Board) (DVW-
709WS/709WSP/790WS/790WSP only)
If you have installed the optional BKDW-704 extension board into the
3
camcorder and are using a cinema lens, you can reverse the orientation of
the image (vertically and horizontally) and record the reversed image as
a normal image.
Setting the Picture Orientation
Use REVERSE IMAGE and H DELAY of OPERATION 2 page of the
setup menu to reverse the picture orientation and horizontally center the
image. To reverse the picture, set REVERSE IMAGE to ON, and use H
DELAY to make fine horizontal adjustments of the picture. (H DELAY
adjustments are possible only when the picture orientation is reversed.
Phase has no effect on pictures which are not reversed.)
Note
After making a horizontal adjustment with H DELAY, always do a test
recording on your system and play it back to verify that the entire picture
fills the screen in the horizontal direction. Any drastic change in the H
phase from the factory setting may cause the picture to be cut off at the
ends, depending on the blanking width and other settings in your editing
system.
3-18
Chapter 3 Recording and Playback